Hõbedane mälupulk võtmehoidjaga – 4GB

Hõbedane mälupulk võtmehoidjaga – 4GB

1.Why is that the USB flash drive actual storage capacity slightly less than the product specification?

All storage product will display a lower than stated memory capacity when they are viewed on a computer. The reason for this discrepancy is the way in which manufacturers calculate a megabyte of memory.
32GB = 32,000,000,000 Bytes
1024Byte = 1K
32,000,000,000/1024 = 31,250,000 KB
1024KB= 1MB
31,250,000/1024 =30,517.57 MB
1024MB= 1GB
30,517.57 /1024 =29.8 GB
Therefore, the capacity of USB flash drive x 0.93 =Windows shown capacity.

2.How do i know my USB flash drive correctly insert into USB port ?

Please make sure your device mental of connector be correctly inserted into meddle of plastic. If your computer still can’t detect your device, please reverse the connector and insert it again.
If your computer detects your device, the first time driver installation process will be shown in the right corner of screen. If your computer device autorun function is enabled, the dialog window will show on the screen. Then you can choose which method you want to open your device. You also can use device manager to check your device status.

3.How can I safety remove my USB Flash drive in Windows operation systems?

The following steps will tell you how to safety remove your USB flash drive:
(1)Find the green arrow icon in the right corner of screen
(2)Right-click on the icon, and select safety remove hardware
(3)Select the USB flash drive you want to remove, mostly it shows with usb mass storage device, then select the usb mass storage after the massage dialog comes out.
(4)Click ok.
(5)Safety remove message will appear immediately in the right corner of screen.
(6)Now can remove your USB flash drive from the USB port.

4.USB flash drive was correctly recognized by my computer,but is does not appear in My Computer,how do I access my flash drive ?

It may that another device was assigned with the same drive letter, because drive conflict. If you want to solve this problem, please follow the instructions below to reassign USB Flash drive initial.
(1)Click Windows start icon.
(2)Select run.
(3)Enter diskmgmt.msc and click on the ok to open disk manager. (4)Right-click on USB flash drive, then select change drive letter and paths.
(5)Click on the edit.
(6)Reassign the drive letter to another one that is not used by another device.
(7)Click on the ok to save your settings.

5.How to prevent files from being damaged or lost from the USB flash drive?

(1)We strongly recommend you to connect your USB flash drive to the rear side USB ports on your computer, and please avoid using an USB hub or extension cable.
(2)Please do not use several USB devices at the same time to avoid the possibility of insufficient power supply.
(3)Please make sure you use the safety remove option whenever you would like to disconnect USB Flash drive from your computer. You can refer to question 12 perform safety remove

6.Why my USB flash drive transfer rate could not reach the speed you claim?

Pretec USB flash drive is following the industrial standard to test the transfer rate. Our test is under the standard of simplest condition and general accepted benchmark.
In the case of usual transfer, the speed will be limited by related hardware and software to reach the expected speed. These factors include:
(1)Motherboard (Driver, Firmware)
(2)The number and format of transferring data Operating System (Version)
(3)Related hardware ( i.e. USB cable, memory and so on)
All of these factors would be slowing down the transfer speed.